Go to…

Buick

Home / Buick

We Service and Repair all Buick cars

  • 2006 Buick Rendezvous

    Buick Rendezvous
    Mileage
    166,971
    Service Date
    8/29/2024
    Services Performed
    • Confirmed poor run condition. Scan computer for trouble codes, has codes present as follows: P0107- MAP Sensor, Signal Low P0131- 02 Signal Low, B1S1 P0171- Fuel System Too Lean, Bank 1 P1106- MAP Sensor Circuit Intermittent High P1107- MAP Sensor Circuit Intermittent Low P1811- Maximum Adapt And Long Shift Found multiple vacuum leaks at PCV tubes/hoses and faulty MAP Sensor. Need to replace before system can be tested further. Customer advised, repairs approved. Renew faulty PCV tubes/hoses/connectors at front and rear valve covers, replace faulty MAP Sensor assy. Clear trouble codes and road test vehicle. No further poor run condition encountered, no recurring codes or check engine lamp.
    • Fuel
     
    Jessica C. gave our service a 5 star review on 8/29/2024

  • 2006 Buick Rendezvous

    Buick Rendezvous
    Mileage
    158,875
    Service Date
    8/29/2023
    Services Performed
    • complaint about spare tire hook hanging from rear. re positioned it.
    • remove and replace headlamp
     
    Jessica C. gave our service a 5 star review on 8/29/2023

  • 2006 Buick Rendezvous

    Buick Rendezvous
    Mileage
    156,575
    Service Date
    5/10/2023
    Services Performed
    • Change oil and oil filter. Perform overall safety inspection. Check all fluid levels, air filter, belts, hoses, etc. Inspect brake linings and check/adjust tire pressures as needed. Inspect exterior lamps/lighting. Reset service reminder indicator (if equipped) .
    • Rotate Tires
    • Purge transmission fluid from system, replace with factory specified fluid, and road test upon completion
    • Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Evacuate brake master cylinder of dirty fluid, claen, and refill, and bleed calipers and/or wheel cylinders until fluid is clean.
    • Replace Cabin Air Filter
    • R&R accessories/components as needed. Remove valve covers, clean all sealing surfaces, renew valve cover gaskets, and reassemble. Road test upon completion, reinspect for leaks. Note: Burning smell may continue for a short period of time while residual oil burns off.
    • System functioning well, no issues noted at this time.
     
    Jessica C. gave our service a 5 star review on 5/10/2023